How to Fix the 'All LocOut' Issue on Your BC75XLT Scanner?

If your new `BC75XLT` scanner is displaying "All Loc Out," it usually means that there are no channels programmed into the device. To resolve this, you'll need to manually add channels and the frequencies you want to listen to. First, ensure that the scanner is turned on after it has been fully charged or that fresh alkaline batteries are installed. Make sure the antenna is connected before powering it on. When you turn on the scanner, you can select the band plan for either the USA or Canada. To do this, press and hold the power key for a few seconds, then press and hold the "1" key for USA or "2" for Canada. This setting will remain until you change it again. If this is your first time using the scanner, it will display "All Loc Out" since no frequencies have been saved yet. To start listening, press the "Srch" button to begin searching for active frequencies. If you encounter any issues while programming, you might want to unlock all channels. To do this, press and hold the "Hold" button to stop scanning, then press and hold the "L/O" button until you hear two beeps and see "CLEAr" on the display. After that, press "E" to unlock all channels. Once you've programmed your scanner with the desired frequencies, it should be fully operational. If you follow these steps, you should be able to enjoy using your new scanner without any issues.