How to Fix Samsung WA422 Washer Not Draining: Troubleshooting Guide
Asked Apr 21, 20130 views1 answer
I am experiencing an issue with my washing machine. When I attempt to run just a spin cycle, it turns slowly for about a minute before stopping, and the lights start blinking. I also notice that there is no sound of water draining. Can anyone help me troubleshoot this problem?
Troubleshooting Samsung WA422 Washer Not Draining
If your Samsung WA422 washer is showing blinking lights and not draining water, you're likely facing a common issue. Here’s a comprehensive guide to help you troubleshoot and potentially resolve the problem.
Symptoms to Look For
- Blinking Lights: Specific lights on the control panel are blinking.
- Slow Spin: The washer attempts to spin but stops after a short while.
- Water Remaining in Tub: The tub is full of water after the spin cycle.
Step-by-Step Troubleshooting
1. Power Reset
Before diving into complex troubleshooting, perform a power reset:
- Unplug the washer or turn off the circuit breaker for 5 minutes.
- Plug it back in or turn on the breaker.
- This can often reset the system and resolve minor glitches.
2. Run a Calibration Mode
Calibration can help the washer understand its load and improve performance:
- Remove all contents from the washer.
- Turn on the machine.
- For the WA422 model:
- Press the Delay Start and Pre Soak buttons simultaneously, then press the button.
Expert Answers
EC
Elixir Cada
Answered Apr 21, 2013
To start troubleshooting your Samsung washer, first try resetting it. Unplug the power cord from the wall or turn off the circuit breaker for about five minutes. After that, turn the breaker back on and plug the washer in again.
Next, run a test cycle. Load about six pounds of laundry into the tub, then press the Power button to turn on the washer. Select the Rinse+Spin cycle by turning the Cycle Selector, and press the Start/Pause button to begin the test. During this cycle, the washer should not rock or vibrate excessively, and it should drain properly during the spin cycle.
If that doesn’t resolve the issue, you can run the Calibration Mode. Make sure there are no clothes in the machine, then turn it on. For the `WA422`, press the Delay Start and Pre Soak buttons simultaneously, then press the Power button. Once the machine is on, press the Start/Pause button to activate Calibration Mode. The pulsator will rotate in both directions for about a minute, and when it's finished, the display will show "En" and the machine will turn off automatically.
If the washer is still not draining, check a few things. Make sure the fuse is intact or reset the circuit breaker. Also, inspect the drain hoses to ensure they aren’t kinked or blocked. If there’s a restriction in the drain, you may need to call for service. Lastly, remember that the washer won’t spin unless the lid is closed, so double-check that as well.
If you find that the tub is still full of water, you’ll need to remove everything from it before running the calibration or any tests. It might be best to take a break and come back to it when you have more time to address the issue thoroughly.
Still need help?
Connect with verified experts who can solve your problem today.